@GrayBackgroundMusic@lemm.eeM to 3DPrinting@lemmy.worldEnglish • 5 months agoCommon printing questionslemm.eeimagemessage-square84fedilinkarrow-up1381
arrow-up1381imageCommon printing questionslemm.ee@GrayBackgroundMusic@lemm.eeM to 3DPrinting@lemmy.worldEnglish • 5 months agomessage-square84fedilink
minus-square@Ahardyfellow@lemmynsfw.comlinkfedilinkEnglish4•5 months agoIf it is a removable bed, pop that bad boy in the freezer for a bit and the print should pop off. If not then you may want to try some glue stick on the bed before a print which will help the print release since it’ll pull off the glue.
minus-square@ArcaneSlime@lemmy.dbzer0.comlinkfedilinkEnglish2•5 months agoIt is, but muh freezer’s full of food and it is glue sticked lol.
minus-square@Ahardyfellow@lemmynsfw.comlinkfedilinkEnglish1•5 months agoDamn that’s wild, what type of bed is it?
If it is a removable bed, pop that bad boy in the freezer for a bit and the print should pop off. If not then you may want to try some glue stick on the bed before a print which will help the print release since it’ll pull off the glue.
It is, but muh freezer’s full of food and it is glue sticked lol.
Damn that’s wild, what type of bed is it?
Ender 5 glass bed.