Hi,
I just have some questions regarding 3D printing. Despite doing this for 2 years I still feel like a beginner.
Questions:
I’m looking at the Ender 5 Plus and Prusa MK3S, I’ve seen plenty of people say the Prusa is better because the Ender 5 Plus requires more “tinkering”. I just feel that the Prusa is overpriced and don’t know if I should just bite the bullet and get it or something else? I want to get back into the printing game.
I live in a trailer and my room is pretty small about 30ft x 30ft, would it be safe to use my printer in my room if all I print is PLA (I’m not talking about using it overnight either since I don’t trust it). Or should I leave it in my living room?
Yup, I’ve only had it for several days, but my MK4 kit I got “just worked” after I assembled it.
I did have to take a look at it yesterday as it was making a clicking/knocking noise. Turns out the applicator took they supply to pack the bearings with grease doesn’t work the best, had to repack the y-axis bearings, no more noise.
Hell, we use two MK3’s at the lab I work at, and they have about 2000 hours of print time between the two of them and they’re just now showing signs of wear (one of the printers had a hotend fail).
Between the fact that they’re open source, they’re damn near bulletproof, and that I worked with them already, getting my MK4 was a no-brainer.
Even a hotbed replacement isn’t that bad. I ended up swapping out the entire hotend when I shorted the thermistor because I thought I also broke the heater cartridge as well. You can partially disassemble the MK3S’s tool head and it’s basically remove-> insert the new part and close it up again - > rewire.