@rustyriffs@lemmy.world to 3DPrinting@lemmy.worldEnglish • edit-210 months agostringing suggestions?message-square33fedilinkarrow-up123file-text
arrow-up123message-squarestringing suggestions?@rustyriffs@lemmy.world to 3DPrinting@lemmy.worldEnglish • edit-210 months agomessage-square33fedilinkfile-text
minus-square@Gorroth@lemmy.worldlinkfedilinkEnglish1•10 months agoNo, I do torch it directly. I use a screwdriver afterwards to form it the way I want it. And a normal gas lighter always leaves soot residue you should avoid to get on your prints.
minus-square@imgonnatrythis@lemm.eelinkfedilinkEnglish2•10 months agoOk. I’m going to give this a try thx.
No, I do torch it directly. I use a screwdriver afterwards to form it the way I want it. And a normal gas lighter always leaves soot residue you should avoid to get on your prints.
Ok. I’m going to give this a try thx.