@swordsmanluke@programming.dev to 3DPrinting@lemmy.worldEnglish • 9 months agoDon't forget to change your z offset after swapping nozzlesmessage-square21fedilinkarrow-up187file-text
arrow-up187message-squareDon't forget to change your z offset after swapping nozzles@swordsmanluke@programming.dev to 3DPrinting@lemmy.worldEnglish • 9 months agomessage-square21fedilinkfile-text
minus-squareLazaroFilmlinkfedilinkEnglish3•edit-29 months agoI preheat to 170°c. That allows the filament to be soft enough to be cleaned (with tweezers or a brush, it peels off in one piece most of the time) without oozing. Then I do a 10mm retract before probing.
I preheat to 170°c. That allows the filament to be soft enough to be cleaned (with tweezers or a brush, it peels off in one piece most of the time) without oozing. Then I do a 10mm retract before probing.
That’s smart!