So I was thinking of adding USBC PD to my ender 3v2 for a off grid setup. Is it possible or have I gone mad with USBC? I know it’s possible with my old monoprice select mini because of its low power requirements.

  • @empireOfLove
    link
    English
    16 months ago

    Sure, but on these fully DC printers all the power control hardware is integrated into the main board and supplied from a single main power rail. You’d have to basically build a separate power control board with that would allow you to isolate those MOSFET’s on their own power rail and then jump the PWM control signal over to it from the main board. Decent amount of electronics knowledge and skill required to pull that off.

    • @evidences@lemmy.world
      link
      fedilink
      English
      16 months ago

      Yeah but why would you need to do that? You’re isolating the second power source behind a relay and switching it using the normal controller.