Hey y’all. I am trying to do a max perimeter style print, and want to know how to remove these smaller sections. I know I could reduce wall count until I remove them, however that isnt dynamic, and leaves larger gaps than I want in other areas. Is there a setting in PrusaSlicer im missing? I messed around with a few but they didnt give me the results I was looking for.

    • @Xzi@lemmy.worldOP
      link
      fedilink
      English
      21 year ago

      They dramatically increase print times and increase blemishes. It’s such a small surface area, that it just ends up creating blobs and shakes the printer.

      • Flaky_Fish69
        link
        fedilink
        2
        edit-2
        1 year ago

        If you’re finding you’re printer is shaking too much, consider adjusting the acceleration/jerk settings

        it’ll slow prints down- the maximum axcel/jerk will limit the top speed for the very short moves, longer moves remain mostly unaffected- but it will improve print quality.

        • @Xzi@lemmy.worldOP
          link
          fedilink
          English
          31 year ago

          I probably should adjust the acceleration settings. In this instance, Im just trying to optimize the print to cut down on print time. There’s about 15 or so of these needlessly small sections per layer, so culling them would cut down the print time a bit.