@Pmdude@lemmy.world to 3D Printing@lemmy.ml • 1 year agoHelp with supportsi.imgur.comimagemessage-square7fedilinkarrow-up19file-text
arrow-up19imageHelp with supportsi.imgur.com@Pmdude@lemmy.world to 3D Printing@lemmy.ml • 1 year agomessage-square7fedilinkfile-text
minus-square@wildergheight@lemmy.worldlinkfedilink3•1 year agoI’m not sure what orientation you’re printing it at but you could try organic supports, those usually take up less surface area. Unfortunately with supports you’re always going to have a rougher surface than printing without them
minus-square@kek_w_lollink6•1 year agoAlso in this case it might make sense to split the model, then glue it together.
I’m not sure what orientation you’re printing it at but you could try organic supports, those usually take up less surface area. Unfortunately with supports you’re always going to have a rougher surface than printing without them
Also in this case it might make sense to split the model, then glue it together.