I haven’t actually done this, I was just brainstorming. It shouldn’t be too hard of a project, though. The easiest would just be an esp32 chip, limit switch, and small battery and power circuit.
You position the switch were the deadbolt latch hits it in the open or closed position (I’d do open personally). Using esphome with homeassistant would make programming it a breeze.
You’d need to figure out a housing, which is why I wish there was an off the shelf product. I might design one eventually, but it shouldn’t be a huge lift for anyone who is familiar with 3d modeling.
How did you integrate this into your door reliably without interfering with the regular lock mechanism?
You could position the sensor/switch on one of the cardinal directions so it wouldn’t be in the way of the mechanism.
Mind sharing a photo of how you did this?
I haven’t actually done this, I was just brainstorming. It shouldn’t be too hard of a project, though. The easiest would just be an esp32 chip, limit switch, and small battery and power circuit.
You position the switch were the deadbolt latch hits it in the open or closed position (I’d do open personally). Using esphome with homeassistant would make programming it a breeze.
You’d need to figure out a housing, which is why I wish there was an off the shelf product. I might design one eventually, but it shouldn’t be a huge lift for anyone who is familiar with 3d modeling.