Anyone try to build a bed occupancy sensor integrated with Home Assistant? I’ve looked into load sensors but all of them seem to have pretty small weight limits (low enough to where I don’t think it would even support the empty bed).
What devices/sensors have you used for this? And what does your setup look like?
@bus_factor Some of the #mmWave (Radar) Presence sensors may be able to detect bed presence through the mattress, mounted under frame. I have not tried this yet but I’ve been planning to. The Aqara FP-1 or Aqara FP-2 are candidates, but maybe too pricey for an experiment. The Apollo MTR-1 is far less expensive and excellent for short range. It is also small and with a sturdy enclosure you could easily place it between and mattress. These sensors can pick up very small motions, even the human heartbeat (sometimes through walls). I use both Aqara (easier set up) and Apollo MTR-1 for room and zone presence detection, with #HomeAssistant for integrated automation.