Bambu p1s
Pla. Its been dried in dehydrator for 4 hours at 55
Ironing is off (seemed to be the same with ironing on)
Ive tried turning the temp down to 210
There is a prime tower and purging is set to 1x
Flow rate is 0.96
Aux fan is off
Relatively new nozzle (less than a couple months old and I dont print that often)
I dont know what other info might be relevant
Its not the absolute top surface though, the black icons are raised higher and those look fine.
Really at a loss. Does anyone have any ideas?
Thanks all. I will look closely while its printing to see if anything is lifting. I do a bed level every print