I’ve been doing 0.08mm layers with a 0.20, I think I just need to be a bit more aggressive with supports. The part has a lot of thin overhangs, which have been blobbing really bad.
Have you played around with the Support Z distance, Support Top Distance, Support Interface? By default (at least with Cura), supports sit a layer or two below where they’re supposed to contact the print so you get shitty overhangs 100% of the time. The tradeoff is that you can easily remove them from the print. You might also try out Tree supports if you haven’t already. They’re a breeze to remove even with zero offset.
I just printed a cable holder for my old macbook charger, one of the foldable hooks broke off. I love fixing broken stuff with my printer!
I’m also experimenting with printing dnd minis with a 0.2 mm nozzle. It mostly works but not quite as good as I would like it to.
You should try a smaller nozzle like 0.15 or 0.20 so you can do clean 0.10mm layers
I’ve been doing 0.08mm layers with a 0.20, I think I just need to be a bit more aggressive with supports. The part has a lot of thin overhangs, which have been blobbing really bad.
Have you played around with the Support Z distance, Support Top Distance, Support Interface? By default (at least with Cura), supports sit a layer or two below where they’re supposed to contact the print so you get shitty overhangs 100% of the time. The tradeoff is that you can easily remove them from the print. You might also try out Tree supports if you haven’t already. They’re a breeze to remove even with zero offset.