edit: you are right, it’s the I/O WAIT that it destroying my performance:
%Cpu(s): 0,3 us, 0,5 sy, 0,0 ni, 50,1 id, 49,0 wa, 0,0 hi, 0,1 si, 0,0 st
I could clearly see it using nmon > d > l > - such as was suggested by @SayCyberOnceMore. Not quite sure what to do about it, as it’s simply my sdb1 drive which is a Samsung 1TB 2.5" HDD. I have now ordered a 2TB SSD and maybe I am going to reinstall from scratch on that new drive as sda1. I realize that’s just treating the symptom and not the root cause, so I should probably also look for that root cause. But that’s for another Lemmy thread!

I really don’t understand what is causing this. I run a few very small containers, and everything is fine - but when I start something bigger like Photoprism, Immich, or even MariaDB or PostgreSQL, then something causes the CPU load to rise indefinitely.

Notably, the top command doesn’t show anything special, nothing eats RAM, nothing uses 100% CPU. And yet, the load is rising fast. If I leave it be, my ssh session loses connection. Hopping onto the host itself shows a load of over 50,or even over 70. I don’t grok how a system can even get that high at all.

My server is an older Intel i7 with 16GB RAM running Ubuntu22. 04 LTS.

How can I troubleshoot this, when ‘top’ doesn’t show any culprit and it does not seem to be caused by any one specific container?

(this makes me wonder how people can run anything at all off of a Raspberry Pi. My machine isn’t “beefy” but a Pi would be so much less.)

  • duncesplayedEnglish
    7·
    1 year ago

    It’s a bit more complicated than that. System load is a count of how many processes are in an R state (either "R"unning or "R"eady). If a process does disk I/O or accesses the network, that is not counted towards load, because as soon as it makes a system call, it’s now in an S (or D) state instead of an R state.

    But disk I/O does affect it, which makes it a bit tricky. You mentioned swapping. Swapping’s partner in crime, memory-mapped files, also contribute. In both of those cases, a process tries to access memory (without making a system call) that the kernel needs to do work to resolve, so the process stays in an R state.

    I can’t think of a common situation where network activity could contribute to load, though. If your swap device is mounted over NFS maybe?

    Anyway, generally load is measuring CPU usage, but if you have high disk usage elsewhere (which is not counted directly) and are under high memory pressure, that can contribute to load. If you’re seeing a high load with low CPU utilization, that’s almost always due to high memory pressure, which can cause both swapping and filesystem cache drops.