#Solved

Our microwave has just begun to show a failure mode. With no settings on the timer/modes when we close the door we hear a 60-cycle hum.

We put a coffee cup with water in and closed the door but did not push any button and noted the hum. The water got warm, for the exposure of 20 to 30 seconds, the water got the expected level of warmth we think.

Is there any danger if we leave the door open? (No hum with the door open)

Could the Magnatron be running at a higher output than it is supposed to when the door is closed but the microwave is not under the control of its built-in circuitry?

Of course, there is no danger of the microwave doing anything other than heating stuff (No mad science going on)? We know that microwave ovens work by making the water molecules vibrate faster.

  • @coldredlight@beehaw.org
    link
    fedilink
    English
    21 year ago

    I’m not an expert but I believe microwaves are generally designed so they can’t run with the door open unless you very intentionally modify them to do so. They shouldn’t fail in a way where it’s possible. That may not be correct, and I would say that regardless you should replace a malfunction microwave because it’s inherently unsafe for other reasons too.

    • WasPentaliveOP
      link
      English
      11 year ago

      We intend to replace it soon. In the meantime, we will leave the door open. We do not hear the humming sound when the door is open. Do you suppose we should unplug the unit? (nontrivial as the unit is an over-the-stove kind with the plug high in a cabinet above the microwave and of course, in the back of the cabinet.)

      • @Esca
        link
        English
        21 year ago

        I would definitely unplug it. If you, someone else, or perhaps even a pet accidentally closes the door and it turns on with nobody realizing it bad things can happen. It will basically microwave itself and if you leave it running long enough it creates a big fire risk. It is a small mistake to make with a high risk.

        • WasPentaliveOP
          link
          English
          11 year ago

          It has been unplugged. I did try unpluging - wait - repluging (reconfiguring the primary power coupling) but that did not resolve the issue.

      • @coldredlight@beehaw.org
        link
        fedilink
        English
        1
        edit-2
        1 year ago

        Ya, it couldn’t hurt to unplug it. Once an appliance starts malfunctioning I’m always concerned about it starting itself on fire. I don’t think it’s especially likely but it feels like it’s worthwhile to mitigate the potential.