Wilshire@sh.itjust.works to Nature and Gardening@beehaw.org · 2 years agoMy 3D printed succulent planters.sh.itjust.worksimagemessage-square25fedilinkarrow-up1152
arrow-up1152imageMy 3D printed succulent planters.sh.itjust.worksWilshire@sh.itjust.works to Nature and Gardening@beehaw.org · 2 years agomessage-square25fedilink
minus-squareWilshire@sh.itjust.worksOPlinkfedilinkarrow-up3·edit-22 years agoI use higher temps, 2mm layer height, 0.6mm line width, and 0.4mm nozzle. I find that going higher than 150% has an effect on my surface quality.
minus-squareHaatveit@beehaw.orglinkfedilinkarrow-up4·2 years agoTrue, it does affect surface quality a bit, but I found that for some uses, it’s was actually desirable or at least tolerable
minus-squareWilshire@sh.itjust.worksOPlinkfedilinkarrow-up1·2 years agoYes, 200% is definitely water tight.
I use higher temps, 2mm layer height, 0.6mm line width, and 0.4mm nozzle. I find that going higher than 150% has an effect on my surface quality.
True, it does affect surface quality a bit, but I found that for some uses, it’s was actually desirable or at least tolerable
Yes, 200% is definitely water tight.